Меню
Количка

Switch DS-3E1528-SI-24T4F HikVision 24 x1000MB+4xSFP

28 Port Aggregation Switch

  • 24 x gigabit RJ45 ports,4 x gigabit fiber optical port
  • Support DHCP snooping
  • Support 802.1Q VLAN
  • Support ACL List
  • Support STP/ERPS loop prevention, storm control
  • Support ARP Anti-Spoofing
  • Support SNMP, QoS
  • 6 kV Surge Protection
  • General
  • ShellMetal material
  • Net Weight2.3 kg (5.07 lb)
  • Gross Weight2.82 kg (6.22 lb)
  • Dimensions (W × H × D)440 mm × 44 mm × 220.8 mm (17.32”× 1.73”× 8.69'')
  • Operating Temperature0°C to 45°C (0 °F to 113 °F)
  • Storage Temperature-40 °C to 85 °C (-40 °F to 185 °F)
  • Operating Humidity5% to 95% (no condensation)
  • Relative Humidity5% to 95% (no condensation)
  • Power Supply100-240 V,50/60 Hz,0.7 A Max
  • Installation ModeRack (equipped with mounting ears)
  • Max. Power Consumption20 W
  • Power Consumption in Idle5 W
  • Surge Protection6 kV
  • Network Parameters
  • Ports24 × gigabit RJ45 port, and 4 × gigabit fiber optical port
  • MAC Address Table8 K
  • Switching Capacity56 Gbps
  • Packet Forwarding Rate41.66 Mpps
  • Internal Cache4.1 Mbits
  • PoE Power Supply
  • PoE Standard/
  • PoE Power Pin/
  • PoE Port/
  • Max. Port Power/
  • Software Function
  • Port Isolation

    Ports 1 to 28: port isolation mode to improve network security

    Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.

  • Link Aggregation

    Link aggregation is used to aggregate multiple physical ports to form a logical port for load balancing, bandwidth expansion, and port protection.

    Support static link aggregation.

    Support 8 aggregation groups.

  • QoS

    QoS is used to allocate bandwidth to different services so as to provide end-to-end service quality assurance.

    Support port-based priority configuration.

    Support SP, WRR priority schedule mode.

  • Loop Prevention

    Loop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default.

    Support 802.1D STP.

  • VLAN

    VLAN is used for network scale planning and network health improvement.

    Support 802.1Q.

    Configurable VLAN ID from 1-4094.

    Support Trunk, Access port mode.

    Support Max. 4094 VLAN.

  • HPP

    Support one-click activation and remote management via Hik-Partner Pro. Functions supported:

    1. Display the port rate.

    2. Display the port bandwidth utilization rate.

    3. Display the PoE power usage.

    4. Display topology information.

    5. Display the alarm status.

    6. Restart ports and devices.

    7. Enable port long-rage mode.

    8. Remotely upgrade the device.

  • System Maintenance

    Support device management via web.

    Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses.

    Support Super IP, which is a fixed IP address (10.180.190.200) for direct access.

    Support management via Hik-Central Pro.

    Support remote management via Hik-Partner Pro.

    Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected.

    Supports 802.1ab LLDP for peer device discovery.

    Support SNMP v1/v2c for third-party management platform access.

    Support port mirroring for fault locating.

  • Port Rate-LimitingPort rate-limiting is used for port bandwidth adjustment to prevent network congestion.
  • Storm Control

    Storm control is used to prevent switch ports from being blocked by broadcast or multicast storms in the LAN, which may affect network communication.

    Support port rate limiting based on broadcast, multicast, and unknown unicast packets.

  • DHCP SnoopingDHCP Snooping can prevent unauthorized connections to DHCP servers from disrupting the network and affecting normal network communication, and only allow DHCP packets from trusted ports to pass through. Disabled by default.
  • ACL

    Port security strategy.

    Support up to 64 ACL entries.

    Support up to 128 configuration rules under all ACL entries.

  • IPSG

    IPSG can control the security of port access device.

    Support port, MAC, IP binding.

    Support 256 security table entries.

  • Approval
  • EMCCE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020),IC (ICES-003: Issue 7:2020),RCM (AS/NZS CISPR 32: 2015)
  • SafetyCE-LVD (EN 62368-1: 2014+A11: 2017),CB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition)
  • ChemistryCE-RoHS (2011/65/EU); WEEE (2012/19/EU); Reach (Regulation (EC) No.1907/2006)

 Технически характеристики

 Инструкции за употреба




Напишете отзив

Бележка: HTML не е преведен!
Лош Добър